Quality Switchgears
From brief to commission.
A Lahore works for LV and LT switchgear — design, manufacture, erection, testing, and handover under one roof since 2002.
- 2002Established
- WorldwideCommission reach
- 2000+Clients served
- ISO 9001Quality system
How we hold the brief.
Purpose, practice, and continuity — read as three commissions.
Purpose
Every commission starts with the client’s drawings, load schedule, and site constraints — not a catalogue shortcut. We fix voltage class, form of assembly, and protection philosophy before any enclosure is cut.
Boards are engineered for industrial and commercial duty under national and international practice. The brief is held until the panel is ready for continuous service: nothing leaves without a clear commission path.
Practice
Schematics, protection settings, and busbar geometry are designed in house. Copper is sized, cut, and dressed on our floor; enclosures are fabricated and wired under total quality control to ISO 9001.
Assembly follows the approved form of assembly cell by cell — from incomers and feeders through control and metering — so the finished board matches the duty it was drawn for.
Continuity
The same works that draws and builds the board commissions it. Installation, insulation and functional tests, and site handover close the path under one roof.
Protection settings are verified against the brief so the board holds for continuous duty after energisation — not only on the works floor, but on site.
Technically sound boards. Nothing leaves without a commission path.
Quality Switchgears manufactures LV and LT switchgear for industrial and commercial sectors across Pakistan. Low-voltage work covers main LT boards and cubicle assemblies with fault, voltage, and thermal protection as specified — finished under ISO 9001.
Control and continuity sit beside power: motor control centres, AMF / ATS, synchronizing and load sharing, power-factor improvement at 415 V, bus-tie duct to 6000 A, terminations, trays, and ladders — engineered and built at Al Ghani Industrial Estate, Ferozepur Road, Lahore.
One works. Design through handover.
Engineering, fabrication, assembly, and testing stay under the same roof. We are registered with the Pakistan Engineering Council and the Lahore Chamber of Commerce & Industry, and hold ISO 9001 certification.
How a board is commissioned
Engineering, fabrication, assembly, and testing stay under the same roof. We are registered with the Pakistan Engineering Council and the Lahore Chamber of Commerce & Industry, and hold ISO 9001 certification.
Consult
Load schedule, specification, and site constraints are fixed before any enclosure is cut.
Design
Schematics, protection settings, and form of assembly are engineered to the duty.
Fabricate
Enclosure, copper, and wiring are built in house under total quality control.
Commission
Installation, testing, and handover close the path for continuous duty.